Kurzweil PC3LE8 Specifications download pdf (Page 321)

Tutorials: Setup Mode

Assigning A Single Knob To Control Relative Volume In Different Zones

14-19

11. With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest

field, press 7 and then the Enter button on the alphanumeric pad to choose Volum e. You can also

use the Alpha Wheel or - / + buttons to select a destination in the Dest field.

12. Now we will set an offset for Zone 3. On the Controllers page for Knob 1, Zone 3, use the cursor

buttons to select the Offset field. On the alphanumeric pad press the +/- button, then 14, then the

Enter button to enter -14 as an offset value.

Knob1(labeledModonthefrontpanel)shouldnowcontrolthevolumeofthepadsonZones2

and3(ifnot,reviewtheprevioussteps.)Zone3willalways

be14MIDIvolumestepsbelow

Zone2becauseoftheOffsetparameter.

13. To finish, press the Exit button to the right of the display to exit the Setup Editor and save your

changes to this setup under a new ID#. SeeTheSetupEditorsectionatthebeginningofthis

chapterfordetailsonsavingwhenyouexittheSetupEditor.

Insetupexampleabove,ifweturnKnob1sothatitissendinga

MIDIcontrollervalueof10,the

MIDIvolumeofZone2wouldbesetto10,andtheoffsetonZone3wouldmeanthatZone3’s

volumeissupposedtobe‐4. SinceMIDIcontrollervaluesdon’tgobelow0,theMIDIvolumeof

Zone3wouldbeset

to0,andtheZonewouldnotbeheard.Inthiscase,Zone3’svolumewould

besetto0foranyKnob1valueof14orless.ThisisadisadvantageofusingtheOffsetmethod,

butitcanalsobeusedcreativelyasawayto“mute”(set

volumeto0)aZonebelowacertain

volume.

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 378 379

No comments

Kurzweil PC3LE8 Specifications Page 321