Kurzweil PC3LE8 Specifications download pdf (Page 328)

14-26

Tutorials: Setup Mode

Assigning A Single Knob to Crossfade Between The Volume Of Different Zones

7. With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest

field, press 7 and then the Enter button on the alphanumeric pad to choose Volum e (see below.)

You can also use the Alpha Wheel or - / + buttons to select a destination in the Dest field.

Knob1(labeledTimbreonthefrontpanel)shouldnowcontrolthevolumeofthepadonZone2,

222ClassPad(ifnot,reviewtheprevioussteps.)

8. With Knob 1 selected in the Controller field, use the cursor buttons to select the Curve field and

then use the Alpha Wheel or - / + buttons to select Compress (see below.) This makes Zone 2

louder when Knob 1 is half way up than it would be with the standard Linear curve. This allows for

the pad sound to be closer to its full volume when Knob 1 is half way up (which will give us an

equal blend of both pad sounds when we are done.)

9. Next, lets repeat the steps above for Zone 3, except this time we will set an Offset and a negative

Scale value to get a crossfading effect. On the Controllers page, use the

Chan/Zone buttons to the

left of the display to select Zone 3 (see below.) You can view the number of the selected Zone in the

top right corner of screen.

10. On the Controllers page for Zone 3, Knob 1 will still be selected in the Controller field. If not,

follow these steps: Use the cursor buttons to select the Controller field. Make sure the LED to the

left of the Timbre Knob is lit, if it is not, press the Shift button to the left of the Knobs until that

LED is lit. Next, hold the Enter button on the alphanumeric pad and move the Knob labeled

1 2 ... 323 324 325 326 327 328 329 330 331 332 333 ... 378 379

No comments

Kurzweil PC3LE8 Specifications Page 328