Kurzweil PC3LE8 Specifications download pdf (Page 330)

14-28

Tutorials: Setup Mode

Assigning A Single Knob to Crossfade Between The Volume Of Different Zones

14. Next we will set a negative Scale value for Zone 3. On the Controllers page for Knob 1, Zone 3, use

the cursor buttons to select the Scale field. On the alphanumeric pad press the +/- button, then 100,

then the Enter button to enter -100% as a Scale value (see below.)

15. Use the cursor buttons to select the Curve field and then use the Alpha Wheel or - / + buttons to

select Expand (see below.) This makes Zone 3 louder when Knob 1 is half way up than it would be

with the standard Linear curve. This allows for the pad sound to be closer to its full volume when

Knob 1 is half way up (which will give us an equal blend of both pad sounds when we are done.)

We are using the Expand curve here instead of the Compress curve as in step 8 (above.) This is

because we used the -100% Scale value for Zone 3, which makes the Expand curve boost middle

values (like the Compress curve usually does,) instead of decreasing middle values as Expand

usually does.

Knob1(labeledTimbreonthefrontpanel)shouldnowcrossfadebetweenthepadsou ndson

Zones2and3(ifnot,reviewtheprevioussteps.)Zone2sendsincreasingvolumevaluesfrom

0‐

127asyouturnKnob1up.Zone3sendsdecreasingvolumevaluesfrom127‐0asyouturnKnob

1up.ThisisbecausetheOffsetof127forZone3makestheZoneset127asavolumewhenKnob

1isdown(sendingavalueof0,

whichgetsaddedtotheOffsetof127,0+127=127.)Zone3then

decreasesinvolumeasKnob1isturnedup,becauseofthe‐100%ScalesetforZone3.

16. To finish, press the Exit button to the right of the display to exit the Setup Editor and save your

changes to this setup under a new ID#. See The Setup Editor section at the beginning of this chapter

for details on saving when you exit the Setup Editor.

1 2 ... 325 326 327 328 329 330 331 332 333 334 335 ... 378 379

No comments

Kurzweil PC3LE8 Specifications Page 330