Kurzweil PC3LE8 Specifications download pdf (Page 326)

14-24

Tutorials: Setup Mode

Assigning A Single Knob to Crossfade Between The Volume Of Different Zones

Assigning A Single Knob to Crossfade Between The

Volume Of Different Zones

YoucanassignaKnobtocrossfadebetweensoundsondifferentZones.Crossfadingallowsyou

tosmoothlyblendbetweentwosoundsbyincreasingthevolumeofoneZoneasthevolumeof

theotherZoneisdecreased.Forexample,let’seditthesetup58 Piano & Pad. The setup 58 Piano

& Pad is a layered setup that uses piano on Zone 1 and “pad” type synth sounds on Zones 2 and 3. Let’s

assign a single Knob to crossfade between Zones 2 and 3. This will allow us to hear either the piano and

one of the pads, or the piano and a blend of both pads.

1. If you are not already in Setup mode, press the

Exit button until you reach the ProgramMode page,

then press the Setup mode button, located with the mode buttons to the left of the display. This will

bring you to the Setup mode main page. Next, press 58 and then Enter on the alphanumeric pad to

select the setup 58 Piano & Pad (see below.) You can also select setups by using the - / + buttons or

Alpha Wheel.

2. With the setup 58 Piano & Pad selected in setup mode, press the Edit button on the front panel.

This will bring you to the CH/PROG page of the setup editor (see below.)

3. From the CH/PROG page, press the CTRLS soft button on the bottom of the screen (see above.)

This brings you to the Controllers page where you can view and assign physical controllers to

destinations for the current Zone.

Step 3

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 378 379

No comments

Kurzweil PC3LE8 Specifications Page 326