Kurzweil PC3LE8 Specifications download pdf (Page 178)

7-56

Setup Mode

The Setup Editor

than100%willresultinshorterdurations,valueslargerthan100%willresultinlonger

durations.

Velocity

VelocitychangesthevelocityofeachMIDInote.Theoriginalvelocitiesofthenotesinthe

sequencearemultipliedbytheselectedpercentage.100%willcausenochange,valuessmaller

than100%willresultin

lowervelocities,valueslargerthan100%willresultinhighervelocities.

Offset

YoucanfinetunethestarttimeofyourriffinticksbyusingtheOffsetparameter. Apositive

valuewilldelaythestarttime,whileanegativevaluewillspeedupthestarttime.

Real-time Control of Riff Parameters

Youcanhavereal‐timecontroloverseveralRiffparameters,byassigningphysicalcontrollersto

specialRiffControllerDestinations.Anyinput(orentryvalue)fromaphysicalcontroller

assignedtoaRiffControllerDestinationoverridestheprogrammedvaluesfortheparametersof

theriffonthatcontroller’szone.Theoverrideremains

ineffectuntilyouselectadifferentsetup.

Remember,eachofthefollowingControllerDestinationsaffectsonlytheriffforthezonewhich

yourcontrollerisassignedto.

Controller

Number

Corresponding

Riff Parameter

Operation

163 RiffOn Riff On. Any value triggers the zone’s Riff if Riff is set to On

on RIFF1 page.

164 RiffOff Riff Off. Any value stops playback of zone’s Riff.

165 RiffDur Riff Duration, sets the Duration parameter (see above.) The

Duration value is calculated by multiplying the received

controller value by 1000, and dividing the answer by 128 (any

decimal points are taken off the final value.) Here are some

example values: 7 = 54%, 13 = 101%,19 = 148%, 32 = 250%,

64 = 500%, 127 = 992%

166 RiffVel Riff Velocity, sets the Velocity parameter (see above.) The

Velocity value is calculated by multiplying the received

controller value by 2. For Example, 25 = 50%, 50 = 100%,

100 = 200%, 127 = 254%.

167 RiffDly Riff Delay, Controls Offset parameter (see above.) Controller

value 64 = 0 offset ticks. Each value away from 64 = 512

offset ticks. For example, 63 = -512 offset ticks, 65 = +512

offset ticks, 0 = -32768 offset ticks, 127 = +32256 offset ticks.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 378 379

No comments

Kurzweil PC3LE8 Specifications Page 178