Kurzweil SPS4-8 Datasheet download pdf (Page 89)

Global Mode

The “Hard Reset?” Dialogue

9-7

If you do have multiple SPS4s receiving Sysex messages from a single source, make sure

each SPS4 has a different Sysex ID. This will allow you to direct Sysex messages to the

appropriate SPS4 by specifying which unit with the Sysex ID byte that’s included with every

Sysex message.

To have the unit respond to Sysex messages regardless of the Sysex ID, set Sysex ID to 127.

The “Hard Reset?” Dialogue

CAUTION: PERFORMING A HARD RESET WILL DELETE ALL USER-CREATED

PROGRAMS AND SETUPS AND WILL RESTORE ALL PARAMETERS TO

DEFAULT VALUES. THIS ACTION CANNOT BE UNDONE.

The “Hard Reset?” dialogue allows you to restore factory defaults to the SPS4. Pressing

Next in this dialogue will change the display to “Conﬁrm?” Pressing Next in the “Conﬁrm?”

dialogue will result in a hard reset—pressing Previous in the “Conﬁrm?” dialogue will recall

the “Hard Reset?” dialogue.

Be sure to save your work off to external storage (See “The “Save All?” Dialogue” on page

9-7). Once deleted, the ﬁles are completely removed from the SPS4 and there is no way to

retrieve them.

To exit the Hard Reset dialogue, simply select another parameter using the Chan / Param

buttons, or enter another Mode using the Mode Functions buttons.

The “Save All?” Dialogue

The “Save All?” dialogue allows you to save every User-bank Program and User-bank Setup

to a computer connected to the unit via USB. You can select Yes by pressing the Next Value

button—pressing Previous will do nothing.

If a computer is connected and you select Yes, the display will show the message “Press

Next for saving the ﬁle”. Pressing Previous will cancel the save operation and recall the

“Save All?” dialogue. Pressing Next will save to the SPS4 temporary drive and the display

will show the message “The ﬁle is in the temporary drive, copy it to your hard disk”. If an

error occurs during the save operation, then the display will show the error message “Save

Error”.

If the SPS4 is not connected to a computer, the display will show the error message “Please

connect the unit to the computer”. Pressing Previous will recall the “Save All?” dialogue—

pressing Next will retry to connect.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 119 120

No comments

Kurzweil SPS4-8 Datasheet Page 89