Kurzweil SP5-8 Specifications download pdf (Page 64)

Setup Mode

User Setups

7-9

In the Save Dialog, there are two parameters available which allow you to specify the ID

number and rename the Setup. Use the rst parameter to change the ID number and the

second to rename the Setup. While the Save button’s LED is blinking, press one of the

Chan / Param buttons to switch between the two parameters.

Changing ID Numbers

To change the ID number, turn the Alpha Wheel or use the Value buttons to select the

number. You can also use the secondary alphanumeric functions of the Category buttons, to

type in a ID number, then press the Enter button. Note that if you select a number out of

range (greater than 1087) and press the Enter button, the ID number won’t change.

Naming a User Setup

To rename the Setup, rst press one of the Chan / Param buttons to change the parameter.

You should see the following in the display:

The bottom line of the display shows the current Setup name. Note that by default the rst

character is selected and the cursor is under it. New Setup names can total 16 characters in

length. (Note that Setup names that are 16 characters in length cause the ID number and

Setup name to scroll marquee-style in the display.) Use the secondary alphanumeric functions

of the Category buttons to enter the new Setup name.

Press the Previous or Next button to move the cursor. Press the +/- button to switch

between upper and lower case characters (all characters will be upper case until you press

the +/- button again). Use the Space button to change the current character to a space, the

Insert button to insert a blank space (all the characters to the right will move one space to

the right), and the Delete button to delete the current character (all the characters to the

right will move one space to the left).

Saving a User Setup

When you nish changing the ID number and naming the Setup, the Save button LED

should still be blinking. Press the Save button to complete the process. Saved User Setups

have an asterisk between the ID number and Setup name.

Rename Setup as: 2/2

New Setup

Setup Xpose:0

1024*New Setup

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 125 126

No comments

Kurzweil SP5-8 Specifications Page 64