Kurzweil SP5-8 Specifications download pdf (Page 16)

Getting Started

Before You Start…

2-1

Chapter 2

Getting Started

This chapter will help you hook up your SP5 to your sound system and MIDI system. If

hooking up new gear is familiar to you, then simply read the following two sections in this

chapter. If you need more information, then be sure to read this chapter in its entirety.

Before You Start…

Don’t connect anything until you make sure your SP5 is properly and safely situated. If your

SP5 has been out in the cold, give it time to warm up to room temperature before starting it,

since condensation may have formed inside.

Quick Start

Make Connections

1. Set the keyboard on a hard, at, level surface.

2. Four adhesive-backed rubber feet are provided with your SP5. If you want to attach

them to the bottom of the SP5 (recommended to prevent scratching your tabletop),

carefully turn the keyboard over, remove the paper backing from the rubber feet and

attach them near each corner all on the same level.

3. Connect the power cable to the adapter then plug the adapter’s DC power cord into your

SP5. Finally, plug the power cable into the wall.

4. Make sure your sound system is at a safe volume level. Also make sure that the SP5’s

MASTER VOLUME slider (on the far left side of the front panel) is all the way down.

5. Plug in a pair of stereo headphones or run standard (1/4-inch) audio cables from

your amplier or mixer to the Audio Outputs on the SP5 (use the Left out for mono).

Balanced (“TRS” or “Stereo”) cables are recommended.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 125 126

No comments

Kurzweil SP5-8 Specifications Page 16